Industrial Maintenance

Details

APPLICATIONS:
Coolant is ideal for use in most water cooled engines either petrol or diesel. It is also highly recommended for automobiles, cranes, trucks, generators, compressors, bulldozers etc. as well as stationary engines on pumps and most motor driven equipment.

ADVANTAGES:

• PREVENT RUST & CORROSION
  Coolant has a multi-phase system to protect iron, aluminum and copper from the crippling effects of corrosion that causes leaks, worn seals and water pump failure.
• STOPS OVER-BOILING OF ENGINE
  The low boiling point of water and the build up of corrosion particles in the radiator tubes leads to boil over and possible severe engine damage. Coolant keeps engine clean and produce maximum cooling efficiency. Thus reduces down time and maintenance costs.
• LONGER PROTECTION
  The specially inhibited radiator additive allows longer protection than any other normal radiator coolant. Flushing only once every 12 months gives full protection to engines running or idle.
• SIMPLE & FAST PROCESS
  Coolant requires only 30 minutes for a year’s protection after every flush, clean and install process. 
• ECONOMICAL
  It can be diluted with water and with very low labor cost to protect the engine system.

DIRECTIONS:

1. System must be pre-cleaned to remove corrosion deposits, dirt, oil and scale. Flush with clean water before adding Coolant into system.
2. Determine the system capacity.
3. Close the drain tightly and add about 20% of the tank capacity with Coolant. Fill the remaining tank capacity with clean water.
4. Tighten radiator cap, start engine and allow solution to re-circulate for 5 minutes.
5. Remove radiator cap and top up with water if necessary.